(a) instructions that are no longer available;
(b) when you find the instructions, they only help a little bit, and some parts amount to "put it all together!".
I have used two pins here. The first is in the rock on Ferrus Manus' left (forward) foot -- or rather the rock that it is attached to. I have pinned the rock horizontally to the other rocks after a lot of slicing away of excess resin to make it fit. It was quite fiddly, and I still might apply some green stuff before painting. The other pin, unsurprisingly, is in the haft of the hammer and into his hands to provide stability. The hammer joint is much to flimsy otherwise in my opinion.
Other pain points included the back pack wherein I was not quite sure what slotted where and how it would hang on his back, but I got there eventually with a lot of dry fitting. And those pturges. Exceptionally fiddlesome and tough to know where and how to slot a number of them (under the shoulder pads, and some on the waist as well.
There is also a rock that I have left off at the front so that I can model or at least make the diorama between Fulgrim and Ferrus (their bases literally join by intent to make a duel pose and diroama possible).
All in all, slightly better to assemble than Fulgrim, perhaps on par with Angron, but not really near the modern primarch models that Forge World have released.
No comments:
Post a Comment